CHLORINE GENERATION - OPERATION
FACTORS WHICH AFFECT CHLORINE RESIDUAL
Model/Size of chlorine generator.
How long the chlorine generator is ON.
Setting of Production Percentage of the chlorine generator.
Salt level.
Water chemistry.
Water temperature.
Covered or uncovered.
Water features.
Bathing load.
Other organic matter (e.g. Phosphates).
AQUAPURE LCD DISPLAY
CELL ON
CELL
RESTING
FLOW
CELL
REVERSING
ADD SALT
SERVICE
CHLORINE
PRODUCTION RATE
Salinity
Pool
Temp
-Boost-
POWER
ON
A
B
C
?
D
?
Flow
No
Wait
Chlorine
Production
%
GPL
100
16
WHAT THE LCD DISPLAY MEANS
50 or 60
- The unit is detecting the electrical supply to optimize the unit settings. 60 cycles power is the
US standard. If the unit detects 60 cycles, it will display the temperature in degrees F. 50 cycles is com-
mon in Europe.
CHLORINE PRODUCTION -
displays the current production percentage rate for chlorine.
WAIT
- the unit is still testing its diagnostics.
NO FLOW
- the unit is still testing its diagnostics, or no water flow is detected.
FLOW
- the flow sensor is indicating to the unit it has enough water flow.
LO
- indicates the water temperature is less than 51 degrees F.
BO
- boost cycle has been activated. Cancel by holding the POOL TEMPERATURE button down for 10
seconds.
EC
- the unit is being controlled by an external controller or ORP device.
JA
- indicates operation is controlled by a Jandy AquaLink RS or PDA, and is in AUTO mode.
JO
- indicates operation is controlled by a Jandy AquaLink RS or PDA, and the system is in SERVICE or
TIMEOUT mode.
JB
- indicates operation is controlled by a Jandy AquaLink RS or PDA, and the system is in BOOST
mode.
WHAT THE INDICATOR LIGHTS MEAN
CELL ON
- Full power is being sent to the cell.
CELL RESTING
- The cell is in the off portion of chlorine production cycle.
Cycle time is 30 minutes. As an
example, when the chlorine production rate is set to 50%, full power will be applied to the cell for 15 min-
utes and then no power (CELL RESTING) for the next 15 minutes.
FLOW
- The sensor is detecting water flow.
CELL REVERSING
- Control switches polarity to the cell every 3 hours to help clean the plates. The cell
will rest for 3 minutes between switching of polarity.
ADD SALT
- Salinity level is 2.5 gpl or less. Should be 3.0 to 3.5 gpl.
SERVICE
- A service problem has been detected. The display will also show one or two error codes.
POWER ON
- Power is being sent to the control and received at the User Interface Board
