Section 3. Installation Instructions
3.1 Materials and Tools
Installation Materials Furnished for
Levolor II, Model K-2000
Qty
Three-probe Sensor with Wire
1
24VAC Solenoid Valve
1
1" Coupler
1
Control Box (K-2000)
1
Remote Sensor Housing
1
Hardware Kit
1
Grease-Filled Wire Nuts for Valve
2 per kit
Screws
4 per kit
Anchors
4
per kit
Installation and Operation Manual -
Warranty Information
1
Additional Materials Needed for Installation
DPST (Dual Pole Single Throw)
24VDC Relay
with
Contacts
Properly Rated for Pump Selected
Anti-Siphon Valve*
2-Conductor
18-Gauge Solid-Core
Burial Cable
Wire Nut Connectors for the Sensor, Relay, and
Power Connections.
*The anti-siphon valve is not necessary if the
connection is made from the irrigation system.
NOTE You can order a 24VDC relay rated for 3 HP
from Jandy (Part No.
R0658100
).
Open the box and check to see that it contains the
contents listed above. If it does not, contact your dealer
or Zodiac technical support at 1 (800)-822-7933.
3.2 Installing the Control Box
1. Mount the control box to the wall near the pump
and filter. See Figure 2. Do not install the control
box within 10 feet (3 meters) of the pool edges.
Fill Line
Anti-siphon
Valve
Filter
Figure 2. K-2000 Installation
2. Mount the control box at eye level. Leave
sufficient clearance on all sides of the chassis
backplate.
3. Check the source voltage.
(The unit is factory
wired for 220 volt operation.) To modify the
wiring for 110 volt operation, see
Section 3.3,
Changing Wiring for 110 Volt Operation.
4. For 220 volt operation, connect the black wire to
line 1 and connect the black wire with the yellow
stripe to line 2. See Figure 3.
Green
Transformer
1
2
5
6
BLK/RED
BLK/WHT
BLK
BLK/YEL
Ground Line 1
Line 2
Figure 3. Factory Wiring for 220 Volt Operation
Page 7
ENGLISH
Jandy Pro Series Levolor
®
II Electronic Water Leveler
Models K-2000
|
Installation and Operation Manual
