- 2 -
nVIDIA N68PV/N68S/N68PVNT User Manual
Primary Master/Slave PIO
Each IDE channel supports a master device and a slave device. These four items let you
assign the kind of PIO (Programmed Input/Output) were used by the IDE devices.
Choose
Auto to let the system auto detect which PIO mode is best, or select a PIO mode
from 0-4.
Primary Master/Slave UDMA
Each IDE channel supports a master device and a slave device. This mainboard supports
UltraDMA technology, which provides faster access to IDE devices.
If you install a device
that supports UltraDMA, change the appropriate item on this list to
Auto. You may have
to install the UltraDMA driver supplied with this mainboard in
order to use an UltraDMA
device.
Secondary Master/Slave UDMA
Ultra DMA/33 implementation is possible only if your IDE hard drive supports it and
the operating environment includes a DMA driver (Windows 95 OSR2 or a third-party IDE
bus master driver). If your hard drive and your system software both support Ultra
DMA/33 and Ultra DMA/66, select Auto to enable BIOS support.
IDE DMA transfer access
This item allows you to enable the transfer access of the IDE DMA then burst onto the
PCI bus and nonburstable transactions do not.
Serial-ATA Controller
Available options:
[Disabled] [Enabled]
IDE Prefetch Mode
The “ onboard” IDE drive interfaces supports IDE prefetch function for faster drive
access. If the interface on your drive does not support prefetching, or if you install a
primary and/or secondary add-in IDE interface, set this option to “Disabled”.
•
Back to Integrated Peripherals Setup Menu
►
MCP Function Setup
Click <Enter> key to enter its submenu:
SATA Operation Mode
This option allows you to select SATA function.
SATA 0 Pri-/Sec- Master/Slave RAID
This option allows you to enable or disable SATA Primary/Secondary RAID.
This is configurable only when “SATA Operation Mode” is set to “RAID”.
•
Back to Integrated Peripherals Setup Menu
・
HDMI Codec Control
Available options: [Disabled] [Enabled].
・
DVI/HDMI Select
This ITEM is Valid on MCP68PV only.
Phoenix - Award WorkstationBIOS CMOS Setup Utility
MCP Storage Config
SATA Operation Mode
x SATA 0 Pri-Master RAID
x SATA 0 Pri-Slave RAID
x SATA 0 Sec-Master RAID
x SATA 0 Sec-Slave RAID
[
IDE
]
Disabled
Disabled
Disabled
Disabled
Item Help
Menu Level
►►
↑
↓
→←
:Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5: Previous Values F6: Fail-Safe Defaults F7: Optimized Defaults
IDE
