22
1. Fasten the first coulter in the center of the main toolbar. Measure 50cm on each side to place the next coulter
and repeat for all 23 coulters. Mount coulters on the main toolbar towards the front and mount coulters on
the wings toward the back (as shown in the picture above).
2. To mount the coulters, place (2) 5/8”-11 x 7-1/8” x 10-1/4” Square
U-bolts facing outward as shown above.
3. Slide the channel bracket plate onto the U-bolts.
4. Set the channel bracket castings onto the U-bolts behind the
channel bracket plate. Thread (4) 5/8” serrated flange nuts onto the
U-bolts but leave the nuts loose.
5. Slide the coulter rod, roll pin, and QJ mounting pad down between
the plate and the casting.
6. Make sure the depression for square head bolt is facing forward
(shown on right).
1
2
2
3
3
4
4
5
5
6
6
7
7
8
8
9
9
10
10
11
11
12
12
Start coulter 1
in the middle
of the main
toolbar
Offset coulter
mounts are
shown in red.
Center line
{ { {
50cm
50cm
50cm
2
1
2
3
Depression
for square
head bolt
Coulter
rod
QJ mounting
pad
Channel
bracket
casting
Channel
bracket
plate
Front view
23 coulters
50cm row spacing
Coulter Mounting - 50cm Row Spacing
Place coulter 2
here.
Place coulter 2
here.
Place coulter 3
here.
