From this point in the instructions only the 4-1/2” filter assembly will be shown in the illustrations however the same
steps must be applied to the 2-1/2” filter system as the remaining instructions are the same.
IS275-17L
J&D Manufacturing • 6200 Hwy 12 • Eau Claire, WI 54701 • 1-800-998-2398 • www.jdmfg.com
Section F - Page 4/6
Section F
Filter System Assembly & Installation
Section F
Mounting Filter Cap Assembly
To provide the space needed to access and service the filters once system is installed, measure and mark 37” from the floor as shown below. Align the top of the
filter mounting plates to this mark and prepare the (4) locations per bracket indicated below for the installation hardware (not included). Secure the mounting
plate to your chosen location.
NOTE:
Mounting location and installation hardware (not included) must be able to withstand the weight of 90lbs, the assembled unit when in use and full
of water.
Mounting
Holes
10
37”
Floor
Floor
Floor
