11
Picture-04
5.4. Measure Procedure
Refer to picture 05
The monitor is designed to take measurements and store the measurement values in
memory for two people using User ID A and User ID B.
1. Sit comfortably in a chair with your feet flat on the floor.
2. Select your User ID (A or B).
Stretch your wrist forward on the desk and keep relaxing, make sure the palm of hand is
upturned. Make sure wrist is in correct position, to avoid body movement. Sit still and do not
talk or move during the measurement.
After the cuff has been appropriately positioned on the wrist and connected to the blood
pressure monitor, the measurement can begin:
a) Press the Stop/Start button. The pump begins to inflate the cuff. In the display, the
increasing cuff pressure is continually displayed.
b) After automatically reaching an individual pressure, the pump stops and the pressure slowly
falls. The cuff pressure is displayed during the measurement.
c) When the device has detected your pulse, the heart symbol in the display begins to blink.
d) When the measurement has been concluded, the measured systolic and diastolic blood
pressure values, as well as the pulse will be displayed.
e) The measurement results are displayed until you switch the device off. If no button is
pressed for 60seconds, the device switches off automatically.
Recommended Use Methods
1.
Recommendation that the PATIENT relax as much as possible and not talk during the
measurement PROCEDURE
2.
Recommendation that 5 min should elapse before the first reading is taken
3.
Any reading can be affected by the measurement site, the position of the PATIENT,
exercise, or the PATIENT’S physiologic condition
4.
Performance of the AUTOMATED SPHYGMOMANOMETER can be affected by extremes
of temperature, humidity and altitude
