background image

12

Instructions for the use of LiPo Batteries

Technical data

Case:

 

The case of the cells consists of an aluminium-plasticfoil. This foil 
should not be damaged under any circumstance, because this will 
lead to a damaged cell. Take care of sufficient protection (i.e. vib-
rations) in the model. If damaged, they might leak, avoid contact 
under all circumstances.

Overcharging: 

If charging does not stop because of any damage to the char-
ger the battery may catch fire. Therefore supervise the charging 
process frequently. 

Speed charging:

Speed charging is not possible. The charging voltage for these 
cells must be followed.

Charging temperature:

 

0 to +45 degrees outside temperature. During charge, the bat-
tery should not get warmer than 70 °C. Supervise the charging 
process with help of the JAMARA Thermo Scan 3000 ( Non-touch 
infrared thermometer)  Order No. 17 0133.

Discharging temperature:

-20 to +60 degrees: Flying in winter is therefore possible. At tem-
peratures beneath 0 degrees, it is likely that the capacity may be 
reduced by approx. 20% and the discharge level may be smaller 
as well

Lifetime: 

Very user-dependent.

Storage:

The cells need to be between half full and full charged. The sto-
raging of empty cells will lead to their destruction. New cells are 
therefore half full.

Charging time:

Charging will take approx. 20 min.
The incl. charger has an automatic charging stop.

Important Notice

Read the manual and the safety precautions for the
Lithium-Polymer-Cells properly.

- Litium-Polymer-Cells have no memory-effect
- Lithium-Polymer-Cells are recharged with a constant voltage and a 
  constant power
- Lithium-Polymer-Cells have a small self-discharging Voltage

Liability exclusion

Jamara e.K. assumes no liability in case of wrong usage or operation 
of the product, respectively of all injuries.
The customer alone is in charge of the cell, this includes from the 
recharging process up to the choice of place of use.
If the customer is not satisfied with the terms of usage, he may use 
his right to return the unused product to the dealer.

 
Lithium-Polymer-Cells may only be stored and recharged, on fireproof 
non-flamable grounds. Jamara e.K. recommends to recharge the cells 
only with the transmitter. When using an other charger or when using 
the permitted charger incorrect, no liability can be taken. Because of 
their enormous power-compactivity Lithium-Polymer-Cells are flamea-
ble when damaged. This can happen through extrem overcharging, a 
crash or a mechanical damage etc. Therefore, it is extremly important 
to supervise the recharging process. After a crash the cell/pack should 
be checked carefully. For example the cell/pack could have been da-
maged, but doesn‘t heat up before 30 minutes. So, in case of a dama-
ge at one pack or a cell always strictly supervise.

If the cell overheats, swells, burns or smoke is coming from it, 
do not touch it under any circumstances. Keep away in a safe 
distance and prepare adequate extinguishing agents such as 
dry powder or sand.

Safety precausions

Because of the high power  compactivity (up to 150 Wh/kg) the cells 
are quite dangerous and need  special care!  The company Jamara 
excludes explicitly, all types of liability for damages, that can occure 
when using the Lithium-Polymer-Cells unproperly.

- When using the battery incorrect there is a risk of getting fire- or  
   acid-injuries.
- Overcharging, too high power, or discharging at low level
   destroys the cell.
- Protect from mechanical stress (squeezing, pushing, bending, 
   drilling).
- Never open or cut open, do not throw into fire, keep away from 
 children.
- Handle damaged or leeking battery with care. Injuries or damages 
   to the gear can occure.
- Under no circumstance short-circuit the device and always watch 
 polarity.
- Protect batteries from heat above 65 °C , mount away from hot  
   objects (for example exhaust pipe).
- Before storing batteries (for example in the winter) charge the 
   battery. Do not store in fully charged or in non charged state!
- If stored over a longer period of time, observe the power level 
 occasionally.
- The contents of the cell is harmfull for skin and eye.
- If the content comes into contact with skin, clean with plenty of 
   water and take off moisted clothes.
- If the content comes into contact with the eyes, clean with
   plenty of water and consult a doctor.
  

Summary of Contents for E-Rix 450





















Reviews: