JAMAR Technologies Traffic Engineering II, User Manual

Page: 36 / 40

Traffic Engineering II Radar User’s Manual
6-2
Troubleshooting
The following are some frequently asked questions related to the Traffic
Engineering II Radar. The possible answers that are stated with them are
not necessarily the only answer, but should be checked first. If you cannot
find the answer to your question, do not hesitate to contact us. Contact
information is listed on page iii of this manual.
When using LiveView, no vehicles are displayed as they pass the site.
What's wrong?
There may be a problem with either how the Traffic Engineering II Radar
was installed or one of the settings that was entered during set up.
First, make sure that you are aiming
the correct area of the Traffic En-
gineering II Radar toward the road.
You should be aiming the crosshairs
printed on the radar head, as shown
in the picture here, at a 45 degree
angle toward the road you want to
record.
Second, check to see if there is
anything between the Traffic Engineering II Radar and the Road that may
be obstructing the 'view' of the recorder.
Third, double checking the distance values entered during the installation
and setup of the Traffic Engineering II Radar.
I want to clear the memory of the Traffic Engineering II
Radar. Can I do that?
Yes, you can clear the memory of the
Traffic Engineering II Radar. To do this, follow the same steps
described on page 3-10.
Additional support information can be found on our web site at www.
jamartech.com. If you are unable to find a solution to your problem,
contact us using the information on page iv of this manual.