̶
21
̶
SW-4000M-PMCL
Main Functions
GPIO (Digital Input/Output Settings)
The unit can input/output the following signals to and from external input/output connectors.
External output
TTL Out (Line1)
DC IN / trigger IN connector (12-pin round)
External input
TTL IN (Line4)
DC IN / trigger IN connector (12-pin round)
CC1 (Line7)
Camera Link cable
These signals can be used as triggers and other necessary signals within the camera or as signals
output from the camera to the system, such as those used for lighting equipment control.
Signals are selected as follows.
• When using external signals or the signals of each GPIO module as trigger signals:
Select in [Trigger Selector] > [Trigger Source].
• When selecting the signals to use for external outputs:
Select in [Line Selector] > [Line Source].
Camera Output Formats
The SW-4000M-PMCL supports a variety of output formats.
The supported tap geometries are as follows.
The tap geometry settings on the camera side and the frame grabber board side must match. For
details on frame grabber board settings, refer to the instruction manual of the board.
Tap geometry
CL configuration
1X2
Base
bit: 8/10
1X3
Base
bit: 8
*1
1X4
Medium
bit: 8/10
1X8
Full
bit: 8
1X8
80 bit (Deca)
bit: 10
1X10
80 bit (Deca)
bit: 8
*2
*
1
Effective pixels are restricted to 4092.
*
2
Effective pixels are restricted to 4090.
■
Cable length reference
The Camera Link cable length is 10 m or less, regardless of the Camera Link clock.
*3
*
3
The length of cable you can use will also vary depending on type and maker.
Exposure Mode
The following operation modes are available on the camera.
Operation mode
Command
Exposure Mode
Trigger Mode
TR
TG
OFF
OFF
0
0
ON
1
Timed
OFF
1
0
ON
1
PWC
ON
2
1
For details on operation mode and function combinations, see “Basic Function Matrix” (page 20).
