JAI GO-5000M-PMCL-UV, User Manual

Page: 22 / 74

— 22 —
GO-5000M-PMCL-UV
Pulse Generator Length
Set the counter up value for the pulse generator. If Repeat Count value is “0” and if Pulse
Generator Clear signal is not input, the pulse generator generates the pulse repeatedly until
reaching this counter up value.
Pulse Generator Start Point
Set the active output start count value for the pulse generator. However, please note that a
maximum 1 clock jitter for the clock which is divided in the clock pre-scaler can occur.
Pulse Generator End Point
Set the active output ending count value for the pulse generator.
Pulse Generator Repeat Count
Set the repeating number of the pulse for the pulse generator. After Trigger Clear signal is input,
the pulse generator starts the count set in Repeat Count. Accordingly, an active pulse which has
a start point and end point can be output repeatedly. However, if Repeat Count is set to“0”, it
works as a free-running counter.
Pulse Generator Clear Activation
Set the clear conditions of clear count pulse for the pulse generator.
Pulse Generator Clear Sync Mode
Set the count clear method for the pulse generator. In case of Async Mode, if the clear signal is
input during the length setting value, the counter will stop counting according to the clear signal
input. In case of Sync Mode, if the clear signal is input during the length setting value, the counter
will continue to count until the end of the length setting value and then clear the count. Both
modes clear the repeat count when the counter is cleared.
Counter clear in Async mode
Counter clear in Sync mode