![background image](http://html1.mh-extra.com/html/jai/cv-a50-ir/cv-a50-ir_operation-manual_3218626019.webp)
CV-A50 IR
7. Configuring the Camera
7.1. RS-232C control.
All configuration of the A50/60 camera is done via the RS-232C port. The camera can be set up
from a PC running terminal emulator software, or using JAI´s camera control software.
Below is the description of the ASCII based short command protocol.
Communication setting.
Baud Rate
9600 bps
TXD
RXD
GND
1 CD
4 DTR
6 DSR
2 RXD
3 TXD
5 GND
7 RTS
8 CTS
9 CI
9 pin
D-con
PC COM
PORT
CAMERA
TXD
RXD
GND
1 CD
4 DTR
6 DSR
2 RXD
3 TXD
5 GND
7 RTS
8 CTS
9 CI
9 pin
D-con
PC COM
PORT
CAMERA
RS 232C cable
Data Length
8 bit
Start Bit
1 bit
Stop Bit
1 bit
Parity None
Xon/Xoff Control None
Fig. 27. RS-232C cable.
Protocol.
Transmit setting to camera:
NN=
[
Parameter
]
<CR><LF>
(NN is any kind of command. Capital or small letters.)
To have all communication visible on the emulator screen, start with:
EB=1<CR><LF>
The camera answers:
COMPLETE<CR><LF>
Transmit the following to see the current parameter for a command:
NN?<CR><LF>
(NN is any commands with parameters.)
The camera answers:
NN=
[
Parameter
]
Transmit the following to see the camera current settings:
ST?<CR><LF>
The camera returns the current parameter settings, firmware and camera type and number.
Transmit the following to get command list help:
HP?<CR><LF>
The camera returns a complete command list.
Unknown commands send to camera: (XY is unknown command).
XY=1<CR><LF>
The camera answers:
01 Unknown Command!!<CR><LF>
Invalid parameters send to camera: (99 is invalid parameter for SH).
SH=99<CR><LF>
The camera answers:
02 Bad Parameters!!<CR><LF>
- 18 -