![background image](http://html1.mh-extra.com/html/jai/cv-a10cl-a70cl/cv-a10cl-a70cl_operation-manual_3217654011.webp)
CV-S3500E
- 10 -
6.3.2 Automatic acquisition of RTC time (SNTP)
The CV-S3500E can acquire RTC time through the network. Set IP address of the SNTP time
distribution server.
6.3.3 User access
Access via HTTP can be controlled by registered ID and Password. In the default setting,
they are not registered. Three user levels can be set: administrator, operator and viewer.
6.3.4 Setup menu
Checking network addresses, setting DHCP, and other tasks can be done through function
keys located on the rear of the camera. Please refer to section 7.3 for the setup menu tree.
6.3.5 Image format through Ethernet interface
In the CV-S3500E, the CCD is scanned in two modes, one for 1280 x 960 and the other for
960 x 720. Data can be digitized in two scan modes. This is done by selecting the scan
mode.
Image types available through the Ethernet interface are shown in the following table.
Still/Movie Format
Scan mode
select
Image size
NTSC/PAL
mode
Frame
rate
Bit rate
Still image JPEG or
Non-
Compression
1280 x 960 1280 x 960
-
-
-
960 x 720
960 x 720
-
-
-
640 x 480
-
-
-
Moving
image
Motion JPEG 1280 x 960 1280 x 960
1 to 2
fps
Normal/High/Super
960 x 720
960 x 720
MPEG4
1280 x 960 640 x 480
NTSC
15 fps
PAL
12.5 fps
960 x 720
640 x 480
NTSC
30 fps
PAL
25 fps
H.264
1280 x 960 640 x 480
NTSC
15 fps
PAL
12.5 fps
960 x 720
640 x 480
NTSC
30 fps
PAL
25 fps
Note:
1. The performance of motion video through the network depends on the traffic conditions of the
network or graphic performance in the PC.
2. RTP movie transfer uses wideband network bandwidth. Accordingly, there may be limitations
in the network.
3. Using HTTP motion video (1280x960), if the quality is set at “super”, the analog output may be
interrupted.
4. If using RTP JPEG and JPEG still image at the same time, the still image is not activated (no
memory error). If using the JPEG still image, RTP should be set at MPEG4 or H.264.