35
DE FR EN
EN
i
nstallation
d
iagram
ATTENTION
1.
The installation must be performed by an electrician or a qualified installer.
2. In order to avoid any risk of electric shock, cut power to the heating/cooling system.
3. Strip the end of each wire if necessary. (Maximum of 6mm)
INSTALLATION
1. Remove the front square frame from the thermostat. (See pictures)
2.
Gently tilt the control panel outwards by placing a small flat head terminal driver or
your thumb into the slot located on the upper part of the thermostat (B).
3. Loosen the screws (A) of the terminal block located at the rear bottom of the
baseplate and insert wires into the respective terminals accordingly. After that,
tighten the screws and remember not to over tighten them as the wires are easily
broken.
4. Fix the baseplate to the wall by using the screws provided.
5. Reinstall the control panel back onto the baseplate and snap the square frame back
to the device as well.
6. Apply power back to the system and program thermostat according to the operating
instructions.
Made in PRC for: JAGO AG, Ingersheimer Str. 12, 70499 Stuttgart / Germany
Tel/Fax-Nr. 0900-1524624 (49 cent/min* from german landline, max. 2,99 Euro/min* from mobile network (*incl. 19% VAT))
A
B
A
A
A
a
a
a
a
b
