ADwin-Pro II
Hardware, manual Dec. 2018
93
Pro II: Analog Output Modules
Pro II-AOut-4/16 Rev. E
ADwin
5.6.1 Pro II-AOut-4/16 Rev. E
The analog output module Pro II-AOut-4/16 Rev. E has 4 DAC (16 bit) with
fixed 1st order low-pass filters (fc = 10MHz).
The module can be ordered in following variants:
The output voltage range of the DACs is set to ±10V bipolar and can’t be
changed. Offset and gain are adjusted by software (see chapter 6 "Calibra-
tion").
Modules with D-Sub female connector have an event input; an event given
may be forwarded as trigger signal to the processor module.
TiCo processor
The variants Pro II-AIn-8/18-xxx-TiCo additionally provide a freely programma-
ble
TiCo
processor with 28 KiByte data memory and 28 KiByte program
memory, which has access to all inputs of the module. Find more information
about use and programming of the
TiCo
processor in the manual
TiCoBasic
.
If you store a
TiCoBasic
program in the
TiCo
bootloader, the program is auto-
matically loaded into the
TiCo
processor and started on power-up. Thus, the
module can run on its own and independently from the CPU module of the
ADwin-Pro II
system.
Fig. 79 – Pro II-AOut-4/16 Rev. E: Block diagram
without TiCo pro-
cessor
with TiCo processor
shielded LEMO female con-
nectors, 1-pole, CAMAC
European norm
Pro II-AOut-4/16
Pro II-AOut-4/16-TiCo
shielded LEMO female con-
nectors, 2-pole, CAMAC
European norm
Pro II-AOut-4/16-L2
Pro II-AOut-4/16-L2-
TiCo
D-Sub female connector 37-
pin
Pro II-AOut-4/16-D Pro II-AOut-4/16-D-TiCo
BNC sockets
Pro II-AOut-4/16-B Pro II-AOut-4/16-B-TiCo
Output channels
4 single-ended
Resolution
16 bit
Settling time to 0.01% FSR
< 3µs
Output voltage
±10V
Fig. 80 – Pro II-AOut-4/16 Rev. E: Specification
2
ADwin-Pro
II
bus
Addr.
Data
Data
Register
Address
Decoder
InAmp
+
-
D
A
1
3
4
LPF
InAmp
+
-
LPF
InAmp
+
-
LPF
InAmp
+
-
LPF
D
A
D
A
D
A
Data
AGND
AGND
AGND
AGND
