1
. Connect the cable(s)
1.1
Connect
the DB26 cable into the VEHICLE port.
1.2
Connect the manual trigger to the DIGITAL I/O port.*
2
. Connect antenna(s)
2.1
Wi-Fi
: Connect the two (short)
4.25in
Wi-Fi antennas to the WiFi-1 & WiFi-2 ports.*
Cellular
: Connect the cellular antennas to the CELL-1 and CELL-2 ports.*
2.2
The 8in 4G:JCG410L cellular antenna(s) are AT&T specific.
2.3
The 3G:JCG016 antenna(s) have a round base stand and cable wire with a
GSM
tag.
2.4
The 4.25in 3G:JCG402 cellular antenna(s) are AT&T/Verizon compatible -- with a
red
-band.
2.5
GPS
: Connect the active/passive (1Hz) antenna receiver to the GPS-A port.*
Active GPS antenna cables are labeled with a
colored
GPS
tag on the cable.
3
. Connect VDR to the vehicle
3.1
Place the VDR inside the vehicle, in a dry location.
Example: Behind the driver seat is a suitable location.
The DB26 cable must reach the vehicles OBD port.
3.2
Connect the DB26 cable (J1962 end) into the
vehicles OBD port. Organize the DB26 cable around
vehicle trim/paneling; to avoid any tripping hazards.
3.3
Allow the VDR software to load: Turn the vehicle
on, and keep the engine running.
4
.
Position connected device(s)
4.1
Place
the GPS receiver on a flat surface.
Placed on the front dashboard is optimal.*
4.2
Place the manual trigger near the driver
seat. Allow for easy access while driving.*
4.3
Optional: Attach the
VDR to the seat.
Optional: Attaching the VDR to driver seat mounts requires
the additional hardware and caution. Avoid installing near
sharp/hazardous objects, to prevent damage.
5
. Confirm VDR lights
A
. Flashing green.
Powered on.
B
. Solid green.
VDR software is running.
C
. Solid green.
Connected to server environment.
E
. Solid green.
GPS signal received.
Limited or no cellular/GPS connectivity
may
occur -
if installing in an environment with a low signal strength.
Examples
: VDR installation location details vary. These are three installation examples.
4.1
: GPS antenna – Front dashboard, below windshield.
4.2
: Manual trigger – Next to driver seat, in center console or in the cup holder
4.3
: Optionally place the VDR (attached to the seat mounts) under the driver seat.
Check the LED lights status -- approximately five minutes after the installation is complete.
1.1
1.2
2.1
2.2
2.4
2.3
2.5
3.2
4.3
4.2
4.1
6
. Ready.
3.1
