Jaga Oxygen Exhaust, Installation And Operating Instructions Manual

Page: 28 / 32

4_Installation
- Determine the place where the unit has to be fixed to the
wall. Check that no wiring or piping runs through the
place for fixing the unit.
- Keep sufficient space around the extraction unit for the
fitting of the suction and blower pipes.
å
Disconnect the black housing from the grey part by
twisting both parts in the opposite direction.
ç
Mark the (four) holes to be drilled on the wall.
When using electrical appliances always observe the pre-
vailing safety instructions. Also carefully read the instructi-
ons below before you install the appliance.
é
Remove the jaw plates depending on the incoming air
current.
è
Screw the box tight using the screws supplied.
ê
Click the key into the box.
ë
Fit the supply ducts on the opened pipes with a fl exible
pipe (diameter > 125 mm).
í
Fasten the unit on the box.
ì
Click the ribs tight on the fl ow sensor.
2
4_In
st
al
lation