Jaga Briza 22, Manual

Page: 32 / 36

32
CO2
PC / RF
INPUT: 110-240VAC
OUTPUT: 24V
N L
CO2
PC / RF
INPUT: 110-240VAC
OUTPUT: 24V
N L
CO2
PC / RF
INPUT: 110-240VAC
OUTPUT: 24V
N L
CO2
PC / RF
INPUT: 110-240VAC
OUTPUT: 24V
N L
4. SETTINGS VIA CIRCUIT BOARD CONTROLLER
4.1. ADJUSTING THE WATER TEMPERATURE
The unit starts from the set temperature / .
4.1.1. Setting the maximum water temperature for cooling
By setting the temperature lower, the unit will start later. If the water temperature is set higher, the unit
will start faster .
1. Start setup mode: hold the [ - ] button until the blue LED flashes 5x and release .
2.
3. Exit setup mode: hold the [ - ] button until the blue LED flashes 5x and release .
4.1.2. set minimum water temperature heating
By setting the temperature higher, the unit will start later. If the water temperature is set lower, the
unit will start faster .
When using a heat pump, it may be necessary to set the water temperature at a lower setting .
1. Exit setup mode: hold the [ + ] button until the red LED flashes 5x and release .
2.
12 ̊C 14 ̊C 16 ̊C 18 ̊C 20 ̊C 22 ̊C 24 ̊C 26 ̊C
The blue LED flashes quickly as soon as the mini-
mum temperature is reached. .
The blue LED flashes quickly as soon as the
minimum temperature is reached. .
The red LED flashes quickly as soon as the maxi-
mum temperature is reached. .
The red LED flashes quickly as soon as the maximum
temperature is reached. .
Automatic control: The green LED lights up when the water temperature (supply water) is lower than the
set temperature
Automatic control: The green LED lights when the water temperature (supply water) exceeds the set
temperature .
Briefly press the [-] or [+] button to adjust the set tempe-
rature .
Briefly press the [-] or [+] button to adjust the set tempe-
rature .
24 ̊C 26 ̊C 28 ̊C 30 ̊C 32 ̊C 34 ̊C 36 ̊C 38 ̊C
3. Exit setup mode: hold the [ + ] button until the red LED flashes 5x and release .
After 30 seconds, the new settings are automatically saved and the device returns to the
selected mode. .
18 28