H 9 6 5 8 5 1
Three Hole Bidet Set
with Vacuum Breaker
FRONT
3
4
4
1
2
COLD
HOT
BIDET
MOUNTING
SURFACE
10˚
VALVE
STEM
10˚
1
1-1/4 MAX.
RED DOT
6
5
3
1
2
Thread LOCKNUT
(1)
to bottom of VALVE BODY
(2)
. Make sure RUBBER WASHER
(3)
and METAL WASHER
(4)
are installed. Insert VALVE BODY
(2)
through mounting hole from underside of bidet mounting surface.
Note: VALVE BODY marked Hot (RED DOT) is installed in the left mtg. hole, VALVE BODY marked Cold (BLUE DOT)
in the right when facing front of fitting.Maximum mounting surface thickness is 1-1/4".
From top install STOP RING
(5)
. Thread ESCUTCHEON
(6)
with seal
washer onto VALVE BODY
(2)
until tight against it's internal stop.
Set VALVE BODIES
(2, 2a)
so that their outlets are facing toward
DIVERTER
(2)
on about a 10 degree angle. Tighten LOCKNUT
(1)
using 35mm or adjustable wrench to secure the valve body.
Repeat above steps for cold VALVE BODY
(2a)
.
BIDET
MOUNTING
SURFACE
RED DOT
BLUE DOT
2a
6
5
COLD
Thread BONNET NUTS
(1)
clock-wise onto VALVE BODY
THREADS
(2)
until seated tightly against ESCUTCHEON
(3)
.
Turn VALVE STEMS
(5)
to off position. Align HANDLES
(4, 4a)
as shown or as desired. Push HANDLES
(4, 4a)
onto VALVE
STEMS
(5).
Tighten with HANDLE SCREWS
(6)
. Install
INDEXES
(7)
. (HOT on the left, Cold on the right).
2
5
1
4
4a
7
6
INSTALL VALVE BODIES
2
INSTALL HANDLES
2
3