1
Turn off hot and cold water
supplies before beginning.
CAUTION
ROUGHING-IN
DIMENSIONS
1 0 9 6 4 4
1 0 9 6 4 4
INSTALL WALL SUPPLY
23-5/8"
3-3/4"
7-5/8"
1-1/8" D.
Plumbers' Putty or Caulking
Adjustable Wrench
Phillips Screwdriver
TOOLS REQUIRED
Regular Screwdriver
WALL SUPPLY
WITH BUILT IN
BACK FLOW
PREVENTER
(1/2)
1-1/16"
1/2
N.P.T.
(48" - 60") (OPTIONAL)
TO FINISHED FLOOR
RUBBER GASKET
FINISHED
WALL
FINISHED
WALL
1/2 NPSM HOSE
CONNECTION
23-5/8"
23-5/8"
1/2" NPT
APPLY SEALANT
5
3`
1
2
3
1
5
C/L
C/L
FINISHED WALL
RECESS IN
MOUNTING
SUPPORT
FROM CENTER TO
CENTER OF WALL
BRACKETS
The ADJUSTABLE SHOWER BAR (1) works best if secured to a wall stud or cross brace within the wall, using the SCREWS (2) supplied.
Supply to WALL SUPPLY (1) is 1/2" NPT. See rough-in above for detailed information.
Install RUBBER SEAL (2) onto WALL SUPPLY (1).
Apply sealant or teflon tape to threads of 1/2" NPT supply nipple. Thread WALL SUPPLY (1)
onto supply nipple making a water tight seal. WALL SUPPLY (1) with RUBBER SEAL (2)
should be tight against finished wall.
If the ADJUSTABLE SHOWER BAR (1) is to be installed on a tile or plaster wall the ANCHORS (3) and SCREWS (2) should be used.
Install RUBBER WASHER (5) in recess of MOUNTING SUPPORT (4). Secure MOUNTING SUPPORT (4) to wall with SCREWS (2).
Install ADJUSTABLE SHOWER BAR (1) onto installed MOUNTING SUPPORTS (4).
Push ADJUSTABLE SHOWER BAR (1) flush against finished wall and tighten
SET SCREWS (5) with (2.5mm) HEX WRENCH (7) supplied to secure
ADJUSTABLE SHOWER BAR (1) to wall.
For installations on drywall or tiled walls:
Use ANCHORS (3) and SCREWS (2) for securing MOUNTING SUPPORT (4) to finished wall.
Drill a 1/4" dia. hole a minimum of 1-3/4" deep. Insert the the ANCHORS (3) flush with face of the finished wall.
Determine desired height and location (optional) and mark a center line. If MOUNTING SUPPORT (4) is secured to a stud or cross brace
drill small pilot holes for SCREWS (2).
2
3
4
INSTALL WALL BRACKETS
INSTALL ADJUSTABLE SHOWER BAR
INSTALL HOSE AND HAND SHOWER
13
11
12
8
10
9
2
7
4
4
5
2
Install SEAL (8) into COUPLING NUT (9). Connect COUPLING NUT (9) to WALL SUPPLY NIPPLE (10) and tighten.
INSTALL second SEAL (11) into SPRAY HOSE END (12 ) and connect HAND SHOWER (13) to SPRAY HOSE END (12).
Hand tighten.
59"
Teflon Tape
