Jadever JWL Series, Manual

Page: 12 / 20

(II)
JWL 11
HOLD/LO/-
to change the value. Press
M+/SAVE
to save and return to weighing mode.
3) Put the load on the container, the scale will automatically deduct the value of the container
from the total value.
NOTE:
Press Key
G/N
to display gross and net weight by turns.
4) Clear the load on the container, and press
TARE/
or
ZERO/ESC
to cancel the pre-tare.
7-3 Check Weighing
Lower limit setting
1. Begin by pressing down key
HOLD/LO/-
.
The scale is now in digital inputting mode with the
right-most digit blinking.
2. To set the value of lower limit, press key
/MR
to shift leftwards, key
TARE/
to shift
rightwards, key
+/PRINT/HI
to increase setting values and key
HOLD/LO/-
to decrease
setting value. Key
M-/SET
to enable or disable the weighing checking function.
3. To save the Lower limit and return to weighing mode, Press key
M+/SAVE
Upper limit setting
1. Begin by pressing down key
+/PRINT/HI .
The scale is now in digital inputting mode with the
right-most digit blinking.
2. To set the value of upper limit, press key
/MR
to shift leftwards, key
TARE/
to shift
rightwards, key
+/PRINT/HI
to increase setting values and key
HOLD/LO/-
to decrease
setting value.
3. To save the upper limit and return to weighing mode, press key
M+/SAVE
Place the sample on the weighing pan, if the sample weight is under the lower weight range while
over or equal 20d, the LOW lamp will light up. If the sample is within the lower and upper weight range
while over or equal 20d, the OK lamp will light up. If the sample is over the upper weight range while