Jacuzzi S198, Owner'S Manual

Page: 13 / 20

Controlling Whirlpool Action
The whirlpool action in your bath is influenced by three
factors – direction of flow, force of water, and force of
air.
Direction: To change the direction of the water flow,
swivel the jet nozzle to the desired angle. The jets can
be directed individually toward any location on your body
to provide a hydromassage. The jets can also be ad-
justed so that they all point in the same direction (clock-
wise or counterclockwise) to circulate the water in a cir-
cular motion around the bath, causing a total whirlpool
effect.
Water Force: The high volume, fully adjustable jets
can be adjusted to control the force of the water coming
into the bath. For robust action, increase the force of
the flow by rotating the jet handles to the left (counter-
clockwise). For a more gentle effect, rotate the handles
to the right (clockwise). Never run the whirlpool sys-
tem with all the jets closed.
Force of Air: Four knobs located on the bath serve as
controls for the air induction system. The intensity of
the hydromassage whirlpool action is determined by the
amount of air inducted into the water. As the amount of
air is increased, the hydromassage action increases.
For maximum air induction, rotate the control knobs fully
counterclockwise to the largest circles. For fewer air
bubbles, decrease the amount of air induction by rotat-
ing the control knob clockwise. When the knobs are
turned to the smallest circles, only water is being
circulated.
TURN CLOCKWISE TO
REDUCE AIR FLOW
TURN COUNTER-CLOCKWISE
TO INCREASE AIR FLOW
AIR INDUCTION CONTROLS
DIRECTIONALLY
ADJUSTABLE
FULLY
ADJUSTABLE
JETS
CD/Radio
For operation of the CD/radio consult the manual en-
closed.
Note: The remote for the CD/radio is not intended to
be used inside the bath.
Note: For units with AM/FM radios, the quality of AM
reception will vary by locality. Jacuzzi Whirlpool Bath is
not responsible for the quality of AM reception.
TV
For operation of the TV consult the manual enclosed.
NOTE: In order to hear the TV audio, the Pioneer CD
Receiver AUX function must be setup to be ON.
To perform this setting:
• If the unit is on, press SOURCE and hold until the
unit turns off.
• Press FUNCTION repeatedly until AUX appears in
he display
• Select AUX on and off with . The status will be
displayed: AUX :ON
If power to the unit is interrupted, the CD Receiver will
have to be reset.
Note: The remote for the TV is not intended to be
used inside the bath.
RapidHeat
Once the heater is installed and the whirlpool pump is
operating, the heating function is totally automatic. The
heater will help maintain the temperature of the water in
the bath.
Vacuum Switch
The heater is equipped with a preset vacuum switch
which will not allow the heater to turn ON if the pump is
not running with water flowing through the whirlpool
system.
High-Limit Switch
The heater includes an exclusive High-Limit switch. This
safety circuit will not false trip from hot tap water. It will
only turn off the heater if the thermostat fails. To reset,
press the button. If the high-limit trips frequently, con-
tact your dealer.
11
PUSH TO RESET
OVER HEAT
PROTECTION
HIGH LIMIT RESET