03/23/05 J600CHT Assembly – DRAFT Prepared for Jacto
Service Seminar 3/2005
DRAFT COPY
Final Assembly and Setup Tips
1)
Install the side step to the holes located on the left lower portion of the frame
using the three bolts supplied.
2)
Install the center piece for the fan cage for the fan disconnect and crimp the end
onto the fan cage to keep the center piece from coming loose.
3)
Perform final inspection of hose clamps, fittings and fasteners to make sure they
are tightened properly. Also check oil level in gear box.
4)
Attach sprayer to the tractor’s three point hitch. DO NOT attach PTO shaft to
tractor’s PTO drive until the PTO shaft has been cut to the proper length. To
determine the proper length required for the tractor being used the operator must lift
the sprayer until the shortest distance between the sprayer’s drive shaft and the
tractor’s PTO drive shaft is obtained. The PTO shaft should have 1 ¼ inch of free
play at this point. Measure the PTO shaft and cut both ends equally to achieve the
free play indicated above.
5)
Add water to tank. Prime pump by removing the cap on the three way valve,
located toward the bottom of the sprayer, and turn the valve handle to allow water to
flow for 1 second to bleed out any air. Return the valve back to the operating
position.
6)
Make sure fan disconnect is engaged before spraying. NEVER attempt to engage
or disengage fan disconnect when fan is turning.
7)
Engage PTO shaft with tractor RPM at low speed and then raise RPM until you
reach 540 RPM at PTO.
Center Piece for Fan
