03/23/05 J600CHT Assembly – DRAFT Prepared for Jacto
Service Seminar 3/2005
DRAFT COPY
Hydraulic Cylinder Assembly
1)
Install the vertical hydraulic cylinder to the movable duct by first installing the
pin that attaches it to the stationary duct. Next install the two brackets with the pins
on the cylinder inserted into the holes on the brackets. Pay close attention to the
positioning of the two brackets as shown below and install the three mounting bolts.
Be careful not to over tighten these bolts or damage to the duct may occur. Install the
paired hydraulic hoses to both the horizontal and the vertical cylinders and route them
through the loops and then through the orange sheath going up to the control valve.