IDENTIFICATION PLATE
On the lower part of the hood there is a plate containing information on
the machine model, serial number, working pressure, motor voltage and other
important data.
For warranty claim, it is necessary to specify data from the identification
plate, mainly the serial number (1), for future service with your dealer.
PRESENTATION OF THE EQUIPMENT
PRESENTATION OF THE EQUIPMENT
MÁQUINAS AGRÍCOLAS JACTO S.A. -
JACTO CLEANING
reserves the right to change its products without prior notice.
01 - Dispenser
02 - High pressure outlet
03 - Trigger gun and high
pressure hose
04 - Electric cable with plug
05 - Water or solution intake
06 - On/off switch
07 - Identification plate
01
02
03
04
(1)
06
10
05
07
CLEANING AND STORAGE
Only use wet cloth to clean this equipment. Never use water, since it can
damage the components. The machine hood must not be cleaned with thinner or
similar substances.
In regions where the temperatures are low, after using the machine, it is
necesssary to drain completely the pump head to avoid damage.
PROCEDURES
Disconnect the suction
hose (1) first and then the high
pressure hose (2).
Switch on the machine for
10 seconds and make sure the
water or solution has been expelled.
NOTE: After a long storage period, the equipment may show a lime
deposit on the pump, which makes difficult to start up the motor. In this case,
before
connecting the machine to the power supply circuit (socket), it will be
necessary to rotate the motor shaft manually to break the lime deposit on the
pump. To do this, introduce a long screwdriver into the central opening on the rear
of the machine until it reaches the motor shaft; then rotate the screwdriver
clockwise several times.
After finishing to clean the machine, store it in a dry and covered place.
Screwdriver
1
2
Motor shaft
23
HIGH PRESSURE CLEANING MACHINE
PRESSURE: 1450 lbf/pol²
FLOW RATE: 360 L/h
MACHINE MODEL: 6800
POWER: 2 CV
FREQUENCY: 60 Hz
VOLTAGE: 220 V - SING
CURRENT: 9 A
MAX. TEMP.: 40º C
Summary of Contents for 6500
Page 2: ......
