Jacobsen Ransomes HR 6010, Service Course Manual

Page: 62 / 76

CUTTER DECK
ADJUSTMENTS
CUTTER DECK BELT TENSION
Check all belts regularly during the first 5, 10
and 15 hours of operation, and then after
every 50 hours of operation. If necessary
adjust as follows:
CENTER DECK
1. Adjust belt tension to 1/2” (13 mm)
deflection at 10 lbs (5 kg) force at the
middle of the long rear span D. If
necessary, adjust as follows:
2. Loosen locking nut on adjustment bolt E.
3. Loosen (4) bolts G fastening the motor
mounting plate to the cutter deck (3 visible
in photo).
4. Turn adjustment bolt E until proper tension
is obtained.
5. Retighten (4) bolts G and lock nut on
adjustment bolt E.
WING DECKS
1. Adjust belt tension to 3/8” (10 mm)
deflection at 10 lbs (5 kg) force at the
middle of the long rear span H. If
necessary, adjust as follows:
2. Loosen locking nut on adjustment bolt L.
3. Loosen two bolts I fastening the idler plate
to the cutter deck.
4. Turn adjustment bolt L until proper tension
is obtained.
5. Retighten bolts I and lock nut on adjust-
ment bolt L.