Jacobsen Ransomes HR 6010, Service Course Manual

Page: 13 / 76

INSTRUMENT PANEL
A.
ENGINE PREHEAT INDICATOR
LAMP
Colour green, on when the ignition switch is
turned clockwise to the pre-heat position.
Once the lamp goes out the engine can be
started.
B. ENGINE TEMPERATURE GAUGE
Indicates current temperature of engine,
whilst running.
C. HYDRAULIC OIL WARNING LAMP
Colour red, on when the hydraulic oil
temperature reaches a preset level. If the
lamp comes on bring the machine to a stop,
disengage the cutting units, apply the
parking brake and stop the engine. The
lamp will also turn on when the charge filter
is blocked.
D. CHARGING WARNING LAMP
Colour red, on when ignition is switched on
and will go out when the engine is started. If
the light comes on while the engine is
running, the fan belt may be slipping or
broken or a fault in the electrical system is
indicated and should be investigated. STOP
IMMEDIATELY.
E. ENGINE OIL PRESSURE
WARNING LAMP
Colour red, on when the ignition is switched
on, and will go out once the engine has
started. If the light comes on while the
engine is running - STOP IMMEDIATELY as
this indicates that the engine oil pressure is
too low. Check the level of oil in the sump
and top up as necessary. Check the oil
pressure sender switch. Continued
operation may cause extensive damage to
the engine.
F. FUEL GAUGE
Located to the left of the engine temperature
gauge. Monitors fuel level.
G: PTO SWITCH
To commence cutting ensure the decks have
been lowered Push bottom of the rocker
switch (A) and depress foot switch. Push top
of rocker switch to stop cutter unit rotation.
(Cutting units stop rotating automatically
when raised.)
H: HEADLIGHT SWITCH
(Optional equipment )-Push switch half way
for running lights. Push down fully for
headlights
I: HAZARD LIGHTS SWITCH
(Optional equipment)- Push down for
flashing hazard lights.
J: TURN SIGNAL LIGHTS SWITCH
(Optional equipment )-rotate switch handle
counterclockwise for L.H. turn and clockwise
for a R.H. turn.
K: HORN
(Optional equipment) press switch to operate
the horn.
L: ROTATING BEACON
(Optional equipment) Press the bottom half
of the switch to activate the flashing beacon.
Controls