Jacobsen Ransomes HR 6010, Service Course Manual, Page: 15 / 76

HEIGHT OF CUT
ADJUSTMENT
The cutting height is determined by the
position of the blades in relation to the caster
wheels. Changes to this height are made at
(4) points and can be made in any order. Make
adjustment selections for each deck from the
height of cut chart for that deck included in this
section.
NOTES
Cutting height must be set the same for all
three decks. The actual height may vary
slightly from the chart value because of tyre
pressure or condition.
HEIGHT OF CUT ADJUSTMENT (CENTRE
DECK)
1. Raise the deck.
2. Remove the quick pin Q from the
top of the caster wheel pivot
spindle
3. Remove the caster wheel from
caster support M.
4. Select either Position 1 or Position
2 for wheel mounting bracket. To
change, remove (4) mounting bolts
R, move to the alternate location
and bolt in place.
5. Place the selected size and
number of spacers below the
caster support. Both A-size (6.5
mm) and B-size (12.5 mm) spacers
are provided. Place the remaining
spacers above the caster support.
6. Replace the quick pin.
7. Place pin P into the proper hole of
bracket for the selected height of
cut.
CENTER DECK HEIGHT OF CUT CHART