7 MAINTENANCE & LUBRICATION CHARTS
en-36
7
MAINTENANCE & LUBRICATION CHARTS
7.1 GENERAL ________________________________________________________________
1.
Always clean the grease fitting before and after
lubricating.
2.
Lubricate with grease that meets or exceeds NLGI
Grade 2 LB specifications. Apply grease with a
manual grease gun and fill slowly until grease begins
to seep out. Do not use compressed air guns.
3.
For smooth operation of all levers, pivot points and
other friction points that are not shown on the
lubrication chart apply several drops of SAE 30 oil
every 40 hours or as necessary.
4.
Grease fittings every 100 hours. Do not over grease
drive shaft fittings (A). Too much grease will damage
the seals.
7.2
LUBRICATION CHART _____________________________________________________
WARNING
Before you clean, adjust, or repair this equipment,
disengage all drives, lower implements to the ground,
engage parking brake, stop engine and remove key
from ignition switch to prevent injuries
!
D
B
D
Brake Fluid
Reservoir
Fuse Box
C
C
A
Fitting
A
B
C
D
Description
Drive Shaft
Upper Ball Joints
Lower Ball Joints
Tie Rod Ends
Qty
2
2
2
4
Summary of Contents for Cushman Turf Truckster
