Jacobsen Bunton 630024, Setup, Parts & Maintenance

Page: 7 / 41

5
Gear
Drive
Midsize
ASSEMBLY/SET-UP INSTRUCTIONS
16. Attach cutterdeck per the instructions on the following pages then return to Step 15 of this section.
17. Fill engine with oil. (See engine manual for specifications.)
18. Fill fuel tank with with clean, fresh unleaded fuel.
GASOLINE IS HIGHLY FLAMMABLE!
• Fill fuel tank with good quality, clean, regular unleaded gasoline.
• Do not use hi-test fuel.
• Do not smoke.
• Do not spill fuel.
• Fill outdoors.
• Do not overfill. Fill to 1" below bottom of filler neck to allow room for expansion.
• USE A FUNNEL TO FILL GAS TANK
19. Adjust tire pressure in drive wheels and casters to 14 psi (1 kg/cm 2 ).
20. Before attempting to start the mower, read and understand all sections of the Operation & Safety
manual.
NOTICE: Special setup instructions.
•
Before engaging the cutterdeck, run the engine for five minutes at full RPM. This is recommended for
new engine installation to permit complete engine lubrication prior to load.
• Do not engage the cutterdeck at full throttle. Set the throttle half way between the highest and lowest
engine speed, engage the PTO switch and increase the engine speed to full before cutting.
•
Do not use this machine without an approved grasscatcher, grass discharge chute or mulching plate(s)
correctly fitted.
15. Move the speed control knob I to the forward
position as shown.
NOTE: To remove the power unit from the crate,
make sure the gear selector handle is in the neutral
position. Push or pull the control levers in the
desired direction of travel. Moving the control levers
will release the parking brakes.