Jacobsen Bunton 630024, Setup, Parts & Maintenance

Page: 21 / 41

19
Gear
Drive
Midsize
WHEEL-DRIVE BELT
1. Raise the back of the power unit and support
with jack stands.
2. Remove swivel A from the upper control plate E.
Rotate the upper control plate E so that the
pulley F moves away from the belt. The swivel
A can be installed in the larger of the two holes
in the control plate E as shown, to hold the
pulley in place while changing the belt.
3. Remove bolts B and spacers C and retain for
later use.
4. Loosen, but do not remove bolt D that holds the
upper control plate.
NOTE: The wheel drive belt will be slack enough to
be removed from its pulleys and passed over the
drive wheel.
5. Re-install bolts, spacers, nuts and swivel.
NOTE: If needed, refer to Page 17 for instructions
on how to adjust the tension to the drive belt.
BELT REPLACEMENT