en-78
8 MAINTENANCE AND LUBRICATION
8.13 CUTTING UNIT 674381 LUBRICATION
_____________________________________
Always clean the grease fitting before and after lubricating.
• Lubricate the following with Shell Darina R2 grease.
• Rear roller (A) weekly of every 25 hours.
8.14 LUBRICATION ________________________________________________________
Always clean the grease fitting before and after lubricating.
Lubricate the following on all with Shell Darina R2 grease:
• Mower pivot (A).
• Front and centre lift arms (B).
Periodically apply a small amount of lithium based grease to the seat runners.
For smooth operation of all levers, pivot points and other friction points that are not shown on the lubrication chart
apply several drops of SAE 30 oil every 40 hours of operation or as needed.
NOTICE
Apply grease with a manual grease gun, do not use a compressed air gun.
Fill slowly until grease begins to seep out.
NOTICE
Apply grease with a manual grease gun, do not use a compressed air gun.
Fill slowly until grease begins to seep out.
A
A
A
B
B
B
A
A
A
Summary of Contents for AR331
