Jacobsen AR3, Safety, Operation & Maintenance Manual

Page: 55 / 76

en-55
JACOBSEN AR3
SAFETY, OPERATORS & MAINTENANCE MANUAL
11.1 GENERAL
The troubleshooting chart below lists basic problems that may occur during start-up and operation. For more
detailed information regarding the hydraulic and electrical systems contact your area Jacobsen Distributor.
11 TROUBLESHOOTING
Symptoms Possible Causes Action
Engine will not start.
1. Glow Plug has not timed out.
1. Reset ignition switch and allow glow plug to
time out before cranking engine.
2. Battery low on charge or
defective. 2. Inspect condition of battery and battery
connections.
3. Fuel tank empty or fuel
contaminated. 3. Fill tank with fresh fuel. Change filter, Bleed air
from lines.
4. Blown Fuse. 4. Replace Fuse.
5. Defective Starter Relay. 5. Test and replace relay if neccesary.
6. Brake switch is not on. 6. Ensure brake switch is on.
7. Mow switch set to cut. 7. Set mow switch to off.
8. Transport pedal not in neutral
8. Remove foot from pedal, cheek pedal returns
to the neutral position.
Engine hard to start
or runs poorly.
1. Fuel tank empty or fuel
contaminated.
1. Fill tank with fresh fuel. Change filter, Bleed air
from lines.
2. Air Cleaner blocked or dirty. 2. Check air cleaner, replace as neccesary.
3. Injectors, fuel pump. 3. Consult engine manual.
4. Other Engine Problem 4. Consult engine troubleshooting guide.
Engine Stops.
1. Fuel tank empty 1. Fill with fresh fuel and bleed lines
2. Interlocks not set before leaving
operators seat 2. Ensure Parking Brake is on & Mow switch is
in the off position.
Engine Overheating.
1. Coolant level low
1. Inspect and add 50/50antifreeze solution if
required.
2. Radiator air intake restricted 2. Clean wire mesh guard at radiator.
3. Waterpump/alternator belt or fan
belt loose or broken. 3. Inspect waterpump/alternator belt and fan belt.
Tighten if neccesary.
Battery not holding
charge. Battery light
on.
1. Loose or corroded battery
terminals.
1. Inspect terminals, clean and tighten as
required.
2. Low electrolyte level in battery. 2. Refill battery with distelled water
3. Alternator belt loose or broken.
3. Inspectwaterpump/alternator belt. Tighten if
neccesary.
4. Alternator defective. 4. See engine manual.
Decks cut unevenly.
Poor quality of cut.
1. Cutting blades are worn. 1. Replace blades.
2. Engine speed too low. 2. Check engine speed, run engine at full throttle.
3. Cutter motors worn.
3. Check case drain leakage & flow check
cutting circuit.
4. Ground speed to high 4. Set work speed stop.
5. Ground weight incorrectly
adjusted 5. Adjust ground weight control valve until correct
ground weight is achieved.