ADJUSTMENTS
3
9
3.2
BRAKE SWITCH ___________________________________________________________
The brake pedal is equipped with a proximity switch. This
switch closes when the brake is engaged. If the operator
leaves the seat without engaging the brake the switch
remains open and will automatically shut the power off.
The switch consists of two pieces, a stationary sensor
(J)
and a magnet
(K)
that pivots with the brake pedal. A
faulty or loose switch can prevent the unit from starting.
For correct operation, adjust air gap
(I)
between magnet
and sensor to 1/16” - 3/32” (1.5 - 2 mm).
Figure 3C
3.3
FORWARD/REVERSE SWITCH _______________________________________________
(neutral adjustment)
If error codes “
-02
” or “-
03
” occur repeatedly the forward/
reverse switch for the traction controller could be out of
adjustment
.
To adjust forward/reverse switch:
1.
Lift hood and remove top cover from electrical box.
2.
Operate forward/reverse pedals and check that
cable linkage is operating smoothly. If cable is
binding, or linkage is bent or damaged, contact an
authorized Jacobsen Dealer for repairs.
3.
Remove screw
(E)
holding cable end to forward/
reverse switch lever.
4.
Back off nut
(F)
which secures rod end
(H)
to cable.
5.
With the cable disconnected, the switch lever
(G)
should return to its neutral position. Adjust rod end
on cable so it aligns directly with hole in lever.
Note:
If the alignment appears correct but the error
code continues to occur, the forward/reverse switch
may be faulty. Contact an authorized Jacobsen
Dealer for repairs.
6.
Tighten jam nut to secure adjustment and reconnect
rod end to switch lever.
7.
Start tractor and check that unit starts and operates
correctly.
Figure 3D
I
K
J
TR022
WARNING
Turn power off, remove key and disconnect the
battery connector before inspecting or working on or
near the electrical system.
!
E
F
G
H
TR014
Summary of Contents for 88006 Sand Scorpion
Page 64: ......
