When using the LSL-HOB battery powered
Limit Stat™, the batteries must be removed
before changing any jumper settings. Wait at
least two minutes after removing the batteries
before changing a jumper or the change will
not be recognized by the thermostat.
JUMPER TABLE UP DOWN
JP1
System Furnace Heat Pump
JP2
Display
Fahrenheit Celsius
JP3
Fan
Gas Electric
JP4
Rev Valve O B
JP1 - System
This setting is not used on the LSL-HOB.
JP2
-
Fahrenheit or Celsius Display
This jumper is used to select degrees F or C
which will be displayed on the LCD.
JP3 - Gas or Electric
This setting is not used on the LSL-HOB.
JP4 - Reversing Valve
This setting is not used on the LSL-HOB
Completing Installation
Thermostat Location
Turn off power to HVAC system
.The Limit
Stat™ should be installed in a location that
represents the ambient space temperature.
Do not install the thermostat in an area where
drafts are present, near the floor, behind
doors or on an external wall. Avoid placing the
thermostat in areas where the air movement
is limited, affected by direct sunlight or other
areas not typical of the temperature in the
space.
1
Mounting the Subbase
When mounting the subbase, be aware that
drafts may travel down wall cavities and enter
the back of the thermostat through the control
wire hole in the wall. It is important to seal the
hole to prevent any drafts that might affect the
internal temperature sensor.
Pull the control wires through the large
opening in the thermostat subbase then level
and mount the subbase on the wall using the
supplied anchors and screws.
Do not over
tighten the mounting screws as the
subbase may warp causing improper
seating of the thermostat connecting pins
to the terminal block.
2
Limit Stat™
G
W1
W2
Y2
Y1
RH
RC
B/O
Use a properly sized screwdriver and land
each wire to its dedicated terminal as
illustrated in Section 4.
Do not over tighten
the terminal screws.
Check to ensure that all wires are landed
correctly and dressed properly to prevent any
shorts.
3
Setup Options
..
.
. .
.
4
Once all optional jumper settings have been
made, replace the batteries. Install the
thermostat on its subbase with the bottom tilted
out. Line up the two holes at the top with the two
hooks on the subbase. Slowly pivot the bottom
of the thermostat towards the subbase and push
firmly until it is securely latched.
