DISHWASHER OPERATING
INSTRUCTIONS
DISHWASHING CYCLE: Once the machine is initially filled, the dishwashing cycle consists of: the
machine washes a rack of dishes, drains the wash water, and then rinses with fresh water which remains
in the machine to wash the next rack of dishes. During the rinse, detergent, rinse additive, and sanitizer
(JP-24LT/LTF) should be injected.
TO FILL THE DISHWASHER
1. Close door and depress Power Switch to On/Fill position and place Cycle Switch to Auto position.
Red power indicator light will light to indicate machine has power turned on and the green light
will come to indicate that machine is automatically filling with water. Proper water level will be
achieved when water touches the bottom of pan strainer.
NOTE: CYCLE SWITCH MUST BE IN THE AUTO POSITION TO FILL MACHINE. MACHINE WILL NOT FILL
IN THE MANUAL POSITION AND WOULD CAUSE PUMP MOTOR TO RUN WITHOUT WATER
WHICH CAN DAMAGE PUMP SEAL.
2. After the wash tank is full of water, the green fill light will go out. Open the door, the amber cycle light
will go out to indicate that the machine is reset for another dishwashing cycle.
3. Placing the Cycle Switch to the center "off" position will allow the door to be opened and closed
without starting an automatic cycle.
4. If door is opened during a dishwashing cycle, machine will stop the cycle until door is closed. When
door is closed, cycle will resume where it was stopped.
TO DRAIN THE MACHINE AT END OF DAY/MEALTIME
5. The dishwasher cycle switch must be in the Auto position in order to drain machine. Machine will not
drain in the Manual mode.
6. Close the door and start a dishwashing cycle without a rack in the machine.
7. Once the cycle has started and the amber cycle light is on, push the Power Switch from the On/Fill
position to the Off/Drain position. The machine will finish the wash cycle and then drain.
MANUAL WASH
8. Place Cycle Switch in the Manual Wash position. In this position, machine will wash indefinitely until
switch in placed in center Off or Auto Cycle position.
8
Summary of Contents for JP-24F
