TO PREPARE PUMPS FOR OPERATION
The CJ-16 dishmachine is supplied with detergent and rinse additive peristaltic pumps. Locate the open ends of the chemical tubes,
insert the end of each tube onto the hub on the brass weight, and place each one in the appropriate container.
A.
Red
Tubing =
Detergent
B.
Blue
Tubing =
Rinse Aid
PRIMING PERISTALTIC PUMPS
Peristaltic pumps need priming when the machine is first installed or if for some reason the chemical lines have been removed and air
is allowed to enter.
CAUTION: Water must be in the sump and wash tank prior to the dispensing of chemicals.
1. Verify that the proper chemical tube inlet is in the correct container.
2. The detergent pump will prime itself, provided there is sufficient chemical available.
3. Detergent is automatically dispensed as required during the wash cycle.
4. When it is required to fill the rinse-agent tubes, e.g. on installation or if the container has been allowed to empty, the system may be
primed as follows:
a) Ensure a cycle is not in progress.
b) Press and hold the drain switch until “rinse-prime” appears in the display.
c) The message “draining” will appear first. The message “rinse-prime” will appear after a few seconds. DO NOT release the
switch when the “draining” message is showing, as this will start a drain cycle. If this is accidentally done, switch off to can-
cel the drain cycle.
d) The rinse-agent pump will run until the switch is released.
e) Observe the rinse agent travelling along the tube. Release the switch when the tubing is full.
Warning: Some of the chemicals used in dishwashing may cause chemical burns if they come in contact with your skin. Wear
appropriate protective gear when handling these chemicals. If you do come in contact with these chemicals flush the area
with fresh water.
CHEMICAL DISPENSING EQUIPMENT
5
