SHUTDOWN AND CLEANING:
At the end of the workday, close
the door. Wait until the cycle is complete and the MODE Switch
lamp is out. Move the MODE Switch UP into the STANDBY posi-
tion, open the door to remove the last rack of ware. On pumped
drain machines, the RIGHT hand switch is blue. Remove the drain
stopper and put in a safe place. (NOTE: The wash tank water will
be hot so caution is advised). Close the door. Press and hold
down the Drain Switch until the message “DRAINING” appears.
IMMEDIATELY release the switch and the drain cycle will start.
The display will tell you when the cycle is complete. Move the
POWER Switch to Off position.
Remove the central knob (A) to remove the wash arms. Check the
nozzles to ensure they are not clogged with debris. If they are,
simply unscrew the nozzle retainer for the affected nozzle and
remove it to clean out the debris. Flush the arms out with fresh
water. IMPORTANT: Remove only one nozzle at a time to ensure
that you replace all of the nozzles as required. Each of the Wash
Nozzles are embossed with either an S or a D. Use the diagram
to the right to refer to nozzle placement. There are no differences
in the Rinse Nozzles.
Remove the lower deflector washer (B) and clean. Notice how the
washer for the lower arm is installed with the lip up. This is very
important. If the deflector washer is not re-installed the same way,
wash performance will suffer tremendously. The upper deflector
washer (C) is only removable by removing the screws that attach
it to the top of the unit. In the event this reflector is removed to be
cleaned, make sure it is reattached with the lip facing downward
away from the top of the unit as shown in the picture below.
Remove the rear, left and right strainer supports and clean as
required. Remove the wash and drain strainers and clean them as
required. Wipe out the entire tub. Use a damp cloth to clean the
tank, never use abrasive material such as steel wool or a wire
brush to clean the tank. Use only cleaners specified for stainless
steel and always follow the manufacturer’s instructions on use of
the cleaner.
WARNING: Do not use substances containing chlorine or bleach
or anything containing hypochlorite compounds, as these chemi-
cals will damage the stainless steel surfaces, and in time will ren-
der the machine useless. Such damage is not covered by the war-
ranty.
OPERATION INSTRUCTIONS (CONTINUED)
9
A
B
C
CJ-16
Wash/Rinse Arm
Assembly
Rinse Arms
Wash Arms
(Thinner)
(Thicker)
S
D
S
D
Blank
Blank
