Jackson Grills LUX400, Owner'S Manual

Page: 7 / 48

7
Closed for Nat Gas
Open ¼” for Propane Gas
Tools Required for Assembly:
Please use the proper tools to simplify installation and avoid injury or damage to your grill.
 TOOLS INCLUDED WITH YOUR GRILL:
1 x 5mm Allen Wrench (for Casters)
 INSTALLER SUPPLIED TOOLS:
1 x Large Phillips Screwdriver
1 x Small Crescent Wrench
Assembling & Preparing your Grill:
 INSTALL CASTERS:
1.
Install locking casters at the front, and the non
-
locking casters at the rear of your grill.
2.
Using the supplied Allen wrench, install the casters by bolting them into the
bottom 4 corners of your grill.
 CHECK BURNER FIT on ORIFICES:
1.
Inspect burners to ensure that they are all inserted correctly onto the orifices
(AKA the outlet of the valves; Fig 1)
2.
If any burner is NOT correctly installed over the valve as shown in Fig 1,
remove the burner retaining clip, remove the burner, and reinstall correctly.
3.
Ensure each air shutter is set correctly. Closed for natural gas or ¼” open for
Propane Gas (See Figure 2). Although we have pre
-
set the air
shutters on the burners of this product, it may be necessary to adjust
them for optimum performance. This is an outdoor appliance and
geography and climate can necessitate an adjustment to the air
shutters. The correct flame characteristics can be found on
page 15 of your owner’s manual.
 INSTALL FLAME DIFFUSERS & COOK GRIDS:
1.
Remove the flame diffusers, grids & warming rack from the packaging.
2.
Install each diffuser directly above each burner by setting them into the slotted
ledges, in the front and rear of the firebox. (Fig. 3)
3.
Once the flame diffusers have been installed, set the cooking grids on the upper
ledges of the firebox in the grill, with the grill bars oriented front to rear.
4.
Install the warming rack above cook grids, on the 2 brackets located on the left
& right inner walls of the inner hood.
 PREPARE REAR BURNER IGNITER:
1.
Unscrew the plastic/rubber cap from the rear burner ignition module, and
insert supplied AAA battery with the positive end facing out. (Fig. 4)
2.
Re
-
install cap.
Figure 1
Figure 3
Figure 4
Tip of brass orifice, on
end of valve; correctly
hidden inside burner.
Main burner
Figure 2