Jackson Grills LUX400, Owner'S Manual

Page: 14 / 48

14
Figure 11
Fuel Conversion:
This grill is convertible to Natural Gas or Propane when needed, with the installation of the appropriate Gas
Conversion Kit. (See parts list, p.20) The kit should be installed by a qualified gas fitter. Please contact your local
dealer for information.
Grill Lighting Instructions:
1.
BEFORE LIGHTING:
•
Always inspect the gas supply hose before turning the gas “ON”. If there is evidence of cuts, wear, or
abrasion, it must be replaced before use. Use only a manufacturer approved replacement hose.
•
Check all gas connections for leaks before each use. Do not light grill if gas odor is present.
2.
TO LIGHT MAIN BURNERS OF THE GRILL: (Fig. 11)
•
Read instructions before lighting (see labels on top edge of the pull out grease tray)
•
Open lid prior to lighting your grill.
•
Turn all knobs to “OFF” then open the propane cylinder valve, OR natural gas valve on your gas connection.
NOTE: Always keep your face and body averted when lighting.
•
Push in and rotate each control knob counter clockwise slowly, to the high position (When rotating the
knob, rotate for a two second count: do NOT turn the knob rapidly) The built
-
in igniter will click and spark,
thus lighting the torch light pilot flame, then the main burner. If the burner does not light IMMEDIATELY turn
the knob to off and wait 5 minutes for gas to dispel and repeat the lighting procedure.
•
Follow match lighting instructions if burner can’t be lit after repeating 3
-
4 times.
3.
TO LIGHT MAIN BURNERS USING A MATCH OR BARBECUE LIGHTER:
(Temporary Solution when Ignition is disabled)
•
Read instructions before lighting.
•
Open the lid during lighting, and remove cook grids.
•
Turn all knobs to “OFF” then open the propane cylinder valve, OR natural gas valve on your gas connection.
NOTE: Always keep your face and body averted when lighting.
•
A long stove match or BBQ lighter must be used to reach the burners.
•
Do NOT drop a burning match into grill for lighting purposes; hold the match in the desired spot.
•
Push and turn the main burner knob to the high position , then release.
•
Light burner by match at the front end of the burner tube. Make sure the burner lights and stays lit.
•
If necessary, call your dealer or the Jackson help line, for assistance with repairing your ignition system.
LOW setting
OFF setting
HIGH setting
& Ignition