Jackle MIG 325, Operating Manual

Page: 34 / 48

MIG 325,405,505
Operating manual Page 31
Gas test (MC 4-5)
To open the gas valve, press the control key ‘gas test’ for more then 1 second. The gas valve is now
open for 20 seconds. After this time the gas valve closes automatically. To close the gas valve earlier,
press the control key again.
Wire feed in
In normal operation (not Job mode!) the wire-feed-in function will be activated by pressing the control
key ‘wire-feed’. The motor is running as long as the key is pressed. The speed can be adjusted by the
left rotating knob.
30. Material table
The following materials are standard in the MC 4 control unit:
Material Display MC Gas
Display
MC
Wire diameter / mm
Steel St Argon 82%, CO
2
18% - MIX 18 Ar82 0,8
Steel St Argon 82%, CO
2
18% - MIX 18 Ar82 1,0
Steel St Argon 82%, CO
2
18% - MIX 18 Ar82 1,2
Steel St Argon 90%, CO
2
5%, O2 5% Ar90 0,8
Steel St Argon 90%, CO
2
5%, O2 5% Ar90 1,0
Steel St Argon 90%, CO
2
5%, O2 5% Ar90 1,2
Steel St CO
2
Co2 0,8
Steel St CO
2
Co2 1,0
Steel St CO
2
Co2 1,2
CrNi 4316 – ER308 4316 Argon 98%, CO
2
2% - MIX 2 Ar98 0,8
CrNi 4316 – ER308 4316 Argon 98%, CO
2
2% - MIX 2 Ar98 1,0
CrNi 4316 – ER308 4316 Argon 98%, CO
2
2% - MIX 2 Ar98 1,2
CrNi 4576 4576 Argon 98%, CO
2
2% - MIX 2 Ar98 0,8
CrNi 4576 4576 Argon 98%, CO
2
2% - MIX 2 Ar98 1,0
CrNi 4576 4576 Argon 98%, CO
2
2% - MIX 2 Ar98 1,2
ALMG 5 ALnG Argon 100% (Ar) Ar 1,0
ALMG 5 ALnG Argon 100% (Ar) Ar 1,2
ALSi 5 ALSi Argon 100% (Ar) Ar 1,0
ALSi 5 ALSi Argon 100% (Ar) Ar 1,2
CuSi CuSi Argon 100% (Ar) Ar 0,8
CuSi CuSi Argon 100% (Ar) Ar 1,0