Jack QB/T2380-2013, Instruction Manual

Page: 22 / 61

12 / 15
3.6.3
监控参数表（开机后按
P
键
+
抬压脚键进入）
Monitoring parameter list (press P + press foot lifter
key to enter)
4
错误代码
Error code
4.1
故障代码表
Error code list
若系统出现报错或报警，请首先检查如下项：
1
先确认机器的连接线是否连接完好；
2
确认电控
和机头是否匹配；
3
确认恢复出厂是否准确。
if have Error or alarm, please check first as follows:1. Check the connection wire is connected or not; 2.
Check the machine head is matched with the control box; 3. check reset is accurate or not.
故障代
码
Error
number
代码含义
Code
meaning
解决措施
Solutions
Err-01
硬 件 过 流
hardware
over-current
关闭系统电源，
30
秒后重新接通电源，控制器若仍不能正常工作，请更换
控制器并通知厂方。
Switch off the power, after 30 seconds, switch on the
power, if control box still cannot work, please change the control box and inform
the supplier. Err-02
软件过流
software
over-current
Err-03
系 统 欠 压
system under
voltage
断开控制器电源，检查输入电源电压是否偏低（低于
154V
）。若电源电压
偏低，请在电压恢复正常后重新启动控制器。若电压恢复正常后，启动控制
器仍不能正常工作，请更换控制器并通知厂方。
Cut off the power of control
box, check input power, the voltage is lower than 154V or not. If it is lower,
please recover the voltage, then restart the control box. if the voltage is normal,
but control box still cannot work, please change the control box and inform the
supplier.
参数编号
number
参数描述
description
参数编号
number
参数描述
description
M10
针数计数值
stitches account
number
M23
初始角度
Initial angle
M11
件数计数值
pieces account number M24
机械角度
Mechanical angle
M13
操作面板软件版本号
panel version
number
M25
踏板前踩模拟量最大值
Max value for pedal forward press
M18
控制器主板软件版本号
main
board version number for control
box M26
踏板回中模拟量采样值
Sample value for pedal back
M20
母线电压
Generatrix Voltage M28
踏板剪线模拟量采样值
Sample pedal value of trimming
M21
机头速度
Machine speed M30-M37
历史故障代码
Historical Error number