85
CAUTION
●
When the ASR is working RPM can decrease even though the accelerator
pedal is depressed fully that is normal condition.
●
Generally the acceleration of vehicle with ASR is better as compared with
the without it. But the braking is same. Do not over speed.
●
The vehicle with ASR/ABS is applied the brake in short time but there is a
difference according to the road status. Leave enough room between your car
and the car in front.
●
On the slippery road especially the frozen pavement the air is cost much by
being operated the ABS/ARS. If the brake warning light is on and the buzzer
sounds
at the same time, pull over the vehicle and wait until the air pressure
increases fully.
●
When you change the tire is not recommended size, consult an authorized
shop.
●
It is possible that the vehicle is driven when the system is out of order.
84
NOTE
If one of the ABS or ASR is out of order the ABS warning light is illuminated. The ASR lamp is on if the engine control
line is out of order even though the ASR system is working normally.
Inspection the system
1. Turn the ignition key to the ON position then the ABS warning light will be on and the ASR lamp be also on. Depress
the brake pedal and the lights will be off to indicate the system is normal.
2. If the ASR light is illuminated continuously
turn the ignition switch off. Try again above
procedure and check the
light is off. If not, the system should be damaged.
NOTE
Though the system is damaged it is possible to drive the vehicle but be careful in moving on the slippery road.
3. Start your engine.
4. If the speed reach 6-10 km/h the ABS warning light will be off to indicate the system is normal.
5. If not, stop your vehicle and try above procedure No.3 and 4 again. If the light is on continuously the system should
be damaged and make it be checked by an authorized JAC service station.
OWNER
’
S MANUAL
JAC HEAVY DUTY TRUCK