background image

Warranty: All products of the company are sold and all services of the company are offered subject to the company’s warranty and terms and conditions of sale, copies of which will be furnished upon request.  The information pro-
vided herein is for guidance only, it does not constitute a guarantee of the performance or specification of any individual product or component.
©Copyright 2006 ITT

DIMENSIONAL DRAWING

Inches (Millimeters)

43000­0606RWD

 Rev:

0312

SMS

Summary of Contents for 22060-7125-C

Page 1: ... cover and impeller to support shaft from impeller end during press operation Do not hammer pulley or coupling on shaft this may damage bearing or seal Capacitor start motor is required to overcome starting torque of impeller 3 SPEEDS 100 RPM to the maximum shown in the performance curves For longer pump life operate at lowest possible speeds Lower speeds are required for viscous liquids consult t...

Page 2: ... Run The Vehicle Engine The hydraulic system is not required during cleaning so no engine fumes are generated in the CIP bay noise is much reduced and unnecessary fuel consumption is eliminated More Effective Cleaning Tests have shown that cleaning is more thorough with the Manual By pass End Cover fitted Extended Pump Life During the cleaning cycle the pump is at greatest risk of running dry If t...

Page 3: ...g 6 To remove bearings from shaft an arbor press is required If an arbor press is not available then a bearing extractor may be used Supporting inner race of bearing apply a steady pressure on shaft until bearing slides free Repeat this procedure to remove second bearing ASSEMBLY 1 To replace bearing on shaft Support bearing on its inner race and locate shaft onto bearing Apply a steady pressure t...

Page 4: ...nd terms and conditions of sale copies of which will be furnished upon request The information pro vided herein is for guidance only it does not constitute a guarantee of the performance or specification of any individual product or component Copyright 2006 ITT DIMENSIONAL DRAWING Inches Millimeters 43000 0606RWD Rev 0312 SMS ...

Reviews: