5
For more information and disclaimer, visit www.jabra.com/aastra
To connect your Aastra phone and Jabra
headset with the DHSG cable, just follow these
simple steps:
SEtting uP thE aaStra iP PhonE
1. Plug the single end of the Y cable in the
headset socket on the phone’s headset port.
2. Connect the large plug in the other end to
the AUX port on the headset base.
3. Plug the smaller RJ9 in the normal phone
socket on the headset base.
Setting up Jabra Pro™ 9400 and
Jabra go™ 6470 – follow the guide
on page 31.
SEtting uP Jabra Pro™ 920
1. Connect the Jabra LINk™ adapter as
shown in adapter documentation supplied
with the Jabra LINk™. On some phones
the telephone cable will also need to be
connected.
2. Call your connected desk phone using
another phone to enable the Jabra LINk™
adapter. Wait 10 seconds before answering.
3. Set a clear dial tone. Locate the clear dial
tone switch on the back of the Jabra PRO
920 base and rotate to “A”.
4. Set the Microphone volume. Make a call
to test your speaking volume. The listener
should not adjust their own volume. You
may adjust your microphone speaking
volume using the + / - volume buttons.
SEtting uP Jabra gn9350e
1. Open up the cover on the base unit.
2. On the LCD display, navigate to the handset
picture.
3. Navigate to the DHSG mode and select it by
pressing the Ok button.
4. Set Compatibility selector in position “A”.
Compatibility selector
Jabra GN9350e
SEtting uP Jabra gn9330e
1. Place the headset in the base with its
indicators facing you.
2. Press the Telephone
button on the Base for
6 seconds while the
headset is in the base until
the headset’s blue LED is
flashing rapidly.
3. Use the volume up/down
button to shift between
the different EHS settings
– see table below.
The base unit’s 4 battery indicators show
which EHS mode the Jabra GN9330e is in.
25 %
100 %
GN RHL (Default)
DHSG
AEI
MSH
Note: If more than 15 seconds elapse without
pressing the or volume – button, the
last selected interface will be activated.
4. Set the base unit to the DHSG mode.
5. To set the EHS mode, press the Telephone
button on the Base for 6 seconds until the
4 battery indicators flash once. Now wait 5
seconds and the headset is initialized.
6. Set Compatibility selector in position “A”.
SEtting uP Jabra gn9120 EhS/
Jabra gn9125
1. Set Compatibility selector (Telephone
Termination Switch Wheel) in position “A”.
2. Set the base unit to the DHSG mode by
keeping the headset in the base and hold
the / - buttons on the headset for
6 seconds until the red light on the base
flashes rapidly.
3. Scroll through the four different settings
using + / - and set to the lips icon. Leave for
15 seconds until the unit has displayed the
confirmation flash sequence and it is ready
to go!
SEt up information
ElEctronic Hook SwitcH (EHS) SolutionS for aaStra
