![background image](http://html1.mh-extra.com/html/jabiru/j170-d-2020/j170-d-2020_pilot-operating-handbook_3120241074.webp)
Jabiru Aircraft
Pilot Operating Handbook
Model J170-D
JP-FM-13
Revision:
0
1
2
3
4
28 Feb 2020
Page 8-74
8. HANDLING AND SERVICING
8.1 INTRODUCTION
This section of the manual provides information on how to handle and service the Jabiru J170-D.
8.2 GROUND HANDLING
– TAXIING
When taxiing, it is important that speed and use of brakes be kept to a minimum. All controls must
be utilized (see Figure below) to maintain directional control and balance; this is particularly
important in windy conditions but is good practice at all times. Using the controls in this manner
makes it less likely for a gust of wind to catch the aircraft and deflect or flip it.
The carburettor heat control knob should be pushed full IN (that is, NOT selected) during all ground
operations unless heat is absolutely necessary.
Taxiing over loose gravel or cinders should be done at low engine speed to avoid abrasion and
stone damage to the propeller.
DO NOT accelerate over loose gravel or cinders or propeller damage will result
Figure 8-1
– Use Of Controls During Taxi
USE UP AILERON ON
LH WING & NEUTRAL
ELEVATOR
USE UP AILERON ON
RH WING & NEUTRAL
ELEVATOR
USE DOWN AILERON
ON LH WING & DOWN
ELEVATOR
USE DOWN AILERON
ON RH WING & DOWN
ELEVATOR