User Manual
Attitude Solo (2nd Generation)
2 Installation
Step-By-Step Installation
The Attitude Solo can be used with any 12 volt power supply. Cut and strip the
wire from your power supply and locate the positive and negative wires. Strip
about 1/4" of insulation off of the end of each wire. Unscrew each terminal of
the power input until there is space in the terminal for the new wire. Insert the
power supply wires into the terminal connector, making sure to establish the
correct polarity. Tighten the screws on the terminal until tight.
POWER SUPPLY
jsquaredsystems.com
The Attitude Solo supports standard DMX-512 output over a 3 pin connection.
To connect lighting fixtures to the Solo, identify each DMX wire. Strip about
1/4" of insulation off of the end of each wire. Unscrew each DMX output
terminal until there is space in the terminal for the new wire. Insert each DMX
wire into the proper terminal: the ground wire should go to the
GND
terminal,
the positive DMX signal wire should go to the
A+
terminal, and the negative
DMX signal wire should go to the
B-
terminal.
DMX OUTPUT
The low voltage trigger on the Attitude Solo provides a convenient way to
manually select lights with specific shows. To activate the trigger, simply
create a momentary connection between the
IN
and
GND
pins on the Solo.
This can be done via a button or momentary relay system. Once activated, the
trigger will stay active for a configurable period of time.
TRIGGER
