17 |
P a g e
Gateway
- Enter the gateway address of your network's router
MAC
- This is the MAC address of your encoder and does not need to be edited.
After you have customized your settings, hit the 'Apply' button at the bottom of the screen. A
notification window will pop up saying that the changes were saved and that a reboot is
required.
To reboot your encoder, navigate to
System > Reboot
After your device has rebooted and your changes have saved, directly connect your
JTECH-ENCH44 encoder to your network switch or router via ethernet cable.
Reconnect your computer to your network switch or router via ethernet cable or ensure you still
have connectivity to the network via WiFi.
If connecting to your network via ethernet, you'll want to change your PC's IP address settings
back from the static IP address you set (192.168.1.100) to DHCP.
Navigate to
Control Panel > Network and Internet > Network and Sharing Center
Then, on the left-hand side select
'Change Adapter Settings'
Summary of Contents for JTD-696
Page 1: ...1 P a g e JTD 696 JTECH ENCH44 4 Input H 264...
Page 6: ...6 P a g e TYPICAL APPLICATION...
Page 34: ...34 P a g e...
