7
QUATTRO LITE MANUAL
6. INSTALLATION OF TRANSMITTER BATTERIES
(8 “AA” ALKALINE BATTERY REQUIRED)
BATTERY CASE ACCESS
Remove the battery cover from the back of the
transmitter as shown. The battery case can then be
removed from the transmitter body. Be careful not
to pull on the battery case wire as damage can
occur to the battery connector.
BATTERY HOLDER AND COVER INSTALLATION
Once the 8 “AA” alkaline batteries have been
installed, turn on the TX switch to insure that all
3 LED lights are lit. This will confirm that the
batteries are at full charge and installed correctly.
Re-insert the battery case, being sure to insert the
lead wires so they will not be pinched when the
battery cover is installed. Replace the battery cover.
BATTERY INSTALLATION
6.1
6.2
6.3
Install the 8 “AA” alkaline batteries (not included)
into the battery holder as shown. When installing
the batteries, please make sure to follow the (+)
and (-) polarity markings on the battery holder.
Installation of the batteries in the incorrect
direction (opposite polarity) can result in damage
to the transmitter.
JRP4477.46 Update Quattro 1/29/01 4:20 PM Page 7
