J+J J4C S20, Handbook

Page: 59 / 91

ASSEMBLY INSTRUCTIONS
HANDBOOK_
KIT DPS_
59
The unit must be disconnected from any electrical power or signal before installing.
1. Remove the screw, which is fixing the hand wheel. (Fig. 2)
2. Remove the 6 screws, which are fixing the body to the cover of the actuator (Fig.3) .
3. Carefully lift the cover (Fig.4) .
4. Remove the cables (from the cover) connected to the actuator PCB
(Fig.5A,5B and 5C)
.
5. Carefully remove the position indicator (Fig.6) .
6. Fix the plastic column (B) on the base plate, by using 2 sheet metal fixing screws
(D)(Fig.7A,7B and 7C)
.
7. Take the DPS cover (A) and connect its cables, following (Fig.8A,8B and 8C) .
8. Place the mentioned cables as per
(Fig.9A and 9B)
.
9. Mount the DPS positioner PCB (C), matching the cleft of the shaft with the key inside the DPS gear (Fig.10) .
10. Press the DPS positioner PCB (C) along the shaft until the PCB connector (JP3) is plugged in the actuator
PCB connector (JP2) (Fig.11).
11. Fix the DPS positioner PCB (C) to the plastic column (B) with the plastic fixing screw
(E) (Fig.12A)
.
12. Connect the remaining cable (A) to the connector base on the DPS PCB (C) (Fig. 12B) .
13. Carefully insert the position indicator, matching its inner key with the cleft of the shaft
(Fig.13)
.
14. In order to set the actuator up, use the DIPs shown in picture (Fig.14) . Put DIP 1 in ON position, connect
the grey connector to the power supply, put DIP 1 back to the prior position. Wait until the actuator make
a complete maneuver (Fig. 14A and 14B) .
15. Disconnect the grey connector from the power supply.
16. Use the configuration you need by moving the DIPs, according to the instrumentation signal
(Fig. 15)
17. Care- fully mount the cover, minding the cables not to be pressed
(Fig.16).
18. Fix the cover to the body by using the 6 screws
(Fig.17)
.
19. Mount the hand wheel on the shaft and fix it by using the screw
(Fig.18)
.
20. Mount the 3 outer connectors together with its rubber joints and fix them to the cover, by using the
screws (Fig.19).
21. Fill in the document inside the kit, and send it to the fax number or e-mail, shown in the document
The unit is ready to work.
Outer Set-Up: Only if necessary.
- B plug - Connect a cable between PIN 1 and PIN Earth (Fig. 20).
- A plug - Connect it to the power supply.
- B plug, disconnect the cable between PIN 1 and PIN Earth.
The actuator will make a complete maneuver.
Connect B connector to the actuator. The actuator is ready to work.
INDEX