-
13
-
8-3. Start
1. Insert SD Card into JS-300G, then power on. Red, Yellow and Blue LED will light sequentially
at a second interval. about 3 seconds after lighting, JS-300G will start running.
If it powers on without SD Card, Red and Green LED will be blinking alternately at 0.5 sec interval.
In this case, disconnect the power and connect power again after inserting SD Card.
2. Recording is run based on Event and Normal record mode (Full Time Mode), and the present
recording mode is saved and memorized into Configuration Variable Setting File in SD Card.
(The Factory default record mode is Event Mode and it would be same after formatting SD Card.)
3. To change the recording mode, connect power under the status of pressing Emergency key
simultaneously.
The mode will be changed either Event Record mode to Normal Record Mode or Normal
Record mode to Event Record Mode.
The changed recording Mode would be saved into SD Card and maintained until the mode is
changed by user. When press Emergency Key, just press it until Red LED turns on.
8-4. Event Record Mode
1. During Event Record Mode, Red LED is blinking at a second interval.
2. When the impact value recognized by G-Sensor (Acceleration sensor) is bigger than User-defined
value or when user presses Emergency key manually, the image and voice before 10 seconds
and after 20 seconds of the event will be saved as a file.
When an event occurs, Red LED will be blinking rapidly at 0.1 second interval for 3 second and
inform of it.
3. Another event occurs while the previous event is saved, the event would be ignored.
(If emergency record is required, just press Emergency button and recording will be started. After
recording, the mode will be back to Event Record Mode.)
Event can be recorded up to 100 times as a file, and from the file recorded first it would be over
written sequentially when the number of file is exceeding the maximum.
4. When the power is disconnected on Event Record Mode, JS-300G would be shutdown after saving
the event, maximum 20 seconds, if it is on recording an event. Otherwise it will be shutdown
instantly.
5. If presses Stop Key, JS-300G will complete recording event and all functions will be stopped. (All
LED lights will be off) to start JS-300G again, disconnect power and connect again.
